Caple CE1500 Manual do Operador descarregar pdf (Página 12)

DIP SWITCHES - SETTING SCSI ID

If you have just one DD1500x-II, you need not concern yourself with this too much as the correct SCSI ID

will have been set at the factory. The default settings for a single drive is SCSI ID#0 and the rear panel DIP

switches should look like this:

However, if you install another drive into the DD1500x-II, the DIP switches should be set as appropriate.

2 4

OFF

DRIVE 1

124

DRIVE 2

2 4

OFF

DRIVE 1

124

DRIVE 2

ID Numbers

DIP Switches

124

0 OFF OFF OFF

1 ON OFF OFF

2 OFF ON OFF

3 ON ON OFF

4 OFF OFF ON

5 ON OFF ON

6 OFF ON ON

7ONONON

SCSI ID#0 is still selected for the first drive. SCSI ID#1 has been set for the second (you may, of course, set

any SCSI ID you like as long as it does not contend with any others on the buss).

Note: In the DD1500 system, the DD1500m is set to SCSI ID #7. Select the ID numbers

other than ID #7.

If you are using other drives in the system, then termination for the second disk in the DD1500x-II should be

switched off (remove the terminator of accessory from connector) and the other drives terminated or

otherwise as appropriate.

If you are in any doubt about SCSI IDs and termination, please consult your dealer. Similarly, if you are in

any doubt about setting up a system with more than one drive, please consult your dealer who will be able to

advise you.

1 2 ... 7 8 9 10 11 12 13 14

Sem comentários

Caple CE1500 Manual do Operador Página 12