Caple CR9215 Informações Técnicas descarregar pdf (Página 25)

 • Removethetwoscrewsseparatingtheburnerfromthe

aeration bracket. See diagram 5.

AR1553

3.1 To remove the injector:

 • Undothelocknutholdingtheaerationbrackettothe

injector. See diagram 6.

AR1554

 • Removetheinjectorfromthefeedpipenotingthe

orientation as this is important when reassembling.

 • Reversetheorderoftheaboveproceduretoreassemble.

 • Checkforleaks.

4. PILOT UNIT

4.1 The pilot unit consists of four components each of which

can be replaced:

– Pilot burner bracket

– Pilot injector

– Electrode

– Thermocouple

 • TakeouttheburnerunitasdescribedinSection2above.

 •Pulltheignitionleadofftherearoftheelectrodeand

remove the electrode from the pilot unit. This helps when

removing the thermocouple and pilot injector. See diagram

7, Arrow A.

 • Undothenutsecuringthethermocoupleandremove

from the pilot burner. See diagram 7, Arrow B.

AR1555

 •Undothenutsecuringthepilotpipeandwithdrawthe

pipe complete with injector hooked onto the olive. See

diagram 7, Arrow C.

 •Reversetheorderoftheaboveproceduretoreassemble.

Check for leaks and flame length. See diagram 8.

AR0620

5. IGNITION LEAD

 • RemovetheburnerunitasdescribedinSection2above.

 • Notetherouteoftheleadanddisconnecttheendfrom

the piezo on the gas control. See diagram 9, Arrow A.

AR1571

 •Disconnecttheleadfromtheelectrodeatthepilotburner

and cut any cable ties.

SERVICING INSTRUCTIONS

REPLACING PARTS

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Sem comentários

Caple CR9215 Informações Técnicas Página 25