Caple C602E Manual de Instalação descarregar pdf (Página 20)

Revision 1.9 - 20 -

5.4

Removal of transportation safety bolts

When lift gate installed properly and basic functions available, transportation safety bolts have to be

removed.

Remove bolts from both swing arms.

Swing arm is able to swing

when platform touches ground

with bolts removed.

Remove the bolts that are underneath the frame

and attached to the bottom of the swing arms

near to the end of lift cylinders.

Figure 12 Removal of transportation safety bolts

By removing the bolts the gate gains the possibility to offset an uneven ground by tilting down the platform

so that the platform is able to lay flat on the surface for an easy loading and unloading.

When bolts are removed test tilting function by lowering lift arm onto a 2” x 4” block. Keep lowering platform

after lift arm touches block to swing arm away from main frame. Platform will tilt down and aluminum tip will

touch ground until steel main section touches ground as well.

While swing arm is detaching from main frame lift cylinders keep retracting to compensate for rotation of

platform. Platform stops lowering down when main section meets ground or cylinders are completely

retracted.

2“x4“ block, simulating

uneven ground

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Sem comentários

Caple C602E Manual de Instalação Página 20