Caple C602E Manual de Instalação descarregar pdf (Página 22)

Revision 1.9 - 22 -

5.4.1

Platform storage Up-stops

With gate power wiring in place and fully functional, place gate and platform in final storage position for

installation of up stops.

- The up stop assembly (x2) and the steel right angle piece (x2) are included with every gate.

Figure 15 Installation of up-stops

- Up Stops MUST be installed to avoid damage to platform when travelling down the road

- The up stop must be mounted high enough so that they do not make contact with the mainframe tube.

- Rubber bumper should make contact with Alum Tip section 1-1/2“ below steel sliding tube (see Figure 14)

- Place the channel so that it is connected to cross members and buck plate, to get the most stability

- The up stops must be mounted rearward enough so that they do not make contact with a tube mounted

aux battery box when the gate is slid out (Figure 15 right picutre)

- The main pin and lift cylinder hoses must clear the up stop when the gate is slid out (Figure 15 left picutre)

Figure 16 Up-stop setup for travel position

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Sem comentários

Caple C602E Manual de Instalação Página 22