Caple C891C Especificações descarregar pdf (Página 3)

DE-COMMISSION OIL SUPPLY AND REMOVE OIL CONTROLS

1. Turn off oil supply, disconnect supply to appliance (preferably outdoors) and cap off. Turn on supply and test for leaks

2. Disconnect and drain oil control valve, taking care not to spill any oil. Remove oil valve and mounting bracket from side

panel.

3. Cap off oil supply pipework using fitting provided. (See Installation Sheet 1, Fig. 2).

4. Remove inner burner housing door.

5. Disconnect oil pipe to burner. Seal pipe, remove oil burner and supply pipe.

6. Remove access plate from base of burner housing and remove pipework.

7. From inside burner housing, remove fire valve probe (feed oil valve cable through guide tube, then feed fire valve probe

out through tube). (See Installation Sheet 1, Fig. 1).

8. Remove thermostat, thermostat knob and fixing bracket from burner housing.

9. Remove thermostat phial (from inside of roasting oven), remove thermostat and phial mounting bracket.

REMOVE INSULATION

1. Remove top plate, insulation and vermiculite from LEFT HAND SIDE of cooker.

2. Remove boiling plate and D-baffle from barrel.

3. Remove barrel.

MODIFICATIONS TO PRE-2000 MODELS ONLY (CAST BURNER HOUSING)

(See Installation Sheet 2, Figs. 1 - 8)

1. Remove phial guide tube from top of burner housing.

2. Open out the hole in the top of the cast burner housing (to take fitting for new flexible conduit). (See Installation Sheet,

Fig. 3).

3. Drill and tap hole in top of roasting oven (for M6). (See Installation Sheet 2, Fig. 1).

4. Open out hole in top LHS roasting oven (as shown). (See Installation Sheet 2, Fig. 2).

5. Fit flexible conduit (guide tube) between top burner housing and hole in roasting oven (fit new bracket to top roasting

oven using M6 screw). (Installation Sheet 2, Fig. 4). Make sure it does not come into contact with outer barrel.

6. Remove bolts from thermometer location casting.

7. Fix casting into place using longer 5/16” screws and washers (provided).

8. Feed new thermocouple and overheat thermostat phial through new guide tube into roasting oven.

9. Fix end of thermocouple and overheat phial to new phial mounting plate. Position thermocouple as shown. (See

Installation Sheet 2, Fig. 7).

10.Fix phial mounting plate onto extended 5/16” screws using 5/16” nuts (provided).

11. Ensure phial and thermocouple are in the groove in the top of the roasting oven, and not touching the cast iron.

1 2 3 4 5 6 7 8 ... 11 12

Sem comentários

Caple C891C Especificações Página 3