Caple C804C Especificações descarregar pdf (Página 147)

HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier MN/HPOD.IOM

Appendix C Revision 8

C–5

C.3.2 Install the New Fan Assembly

Figure C-3. Install the New HPOD Fan Assembly

To install the new fan assembly, do these steps:

Step

Task

Visually inspect the exposed SSPA heat sink for any debris or blockage. Use compressed air to clear

and clean the heat sink as needed.

Connect the fan assembly’s circular connectors to the SSPA.

Position the fan assembly onto the SSPA. Make sure that you align the assembly properly, so that you

can bolt down the fasteners without any cable or fan interference.

Tighten the four captive fasteners where shown previously in

Figure C-2

Be sure to use an appropriate screwdriver, such as the one provided

with the SSPA, to avoid damaging the fasteners.

Reconnect the HPOD SSPA to its power source.

1 2 ... 142 143 144 145 146 147 148 149 150

Sem comentários

Caple C804C Especificações Página 147