Caple C804C Especificações descarregar pdf (Página 55)

HPOD C, X-, or Ku-Band High-Power Outdoor Amplifier MN/HPOD.IOM

Ethernet-based Remote Product Management Revision 8

4–7

3) Enter the User name and password (the default for both is comtech):

4) Use the LRS remote command to set the Ethernet remote control access parameter:

• Use default remote command LRS=3 for Serial + Ethernet control

• Use remote command LRS=2 for Ethernet control only.

5) If necessary, use the IPA remote command to set a unique IP address.

1) Each HPOD must have a unique IP address assigned before connection

to a network. If the IP address needs to be changed from the factory

default setting, use the IPA=xxx.xxx.xxx.xxx.yy remote command,

where ‘xxx.xxx.xxx.xxx’ is a valid IP address on the network where the

unit will be installed, and ‘yy’ is the range (typically, yy=24).

2) If you change the IPA value, make sure to shut off and restart the unit;

then, start a new Telnet session using the new IP address.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 149 150

Sem comentários

Caple C804C Especificações Página 55