Caple C871i Manual do Utilizador descarregar pdf (Página 34)

100

101

Apple II Computer Info

going to the other side of each button

switch at the non-switch end. If a wire

runs from one switch to the other,

leave it alone. If not, connect a wire

from switch to switch. This is the

"common" side of the switches.

You want to end up with a single wire

going to the common side of the switches

and separate Button 0 and Button 1 wires

going to the other side:

____Button 0 wire

X B0 Switch

------- COMMON Wire

X B1 Switch

|____Button 1 wire

Label the COMMON wire as "GROUND"

4. The 330k resistors will help bring the

outputs of the Apple2 X and Y 150k Ohm

pots closer to the 0-100k range PC

prefers. Connect a 330k resistor

'across' each pot-- i.e. from the center

post to the post going to a +5 lead.

5. Label each of the leads coming from

the PC cable. If it is still connected

to a joystick, the following pic will

help identify each lead:

PC Joystick

(15-pin female connector)

[1]--------------- +5V

[2] -------------- Button 0

[3] -------------- X-axis

[6] -------------- Y-axis

[7] -------------- Button 1

[4] and [5] --- Ground

If the cable is still connected, snip the

the leads once they are all labeled. If

both Ground ([4] and [5]) leads are

present, twist them together and treat

like a single Ground lead.

FINISHING UP

You have six labeled wires in the

Apple2 joystick case: +5, GROUND, B0,

Apple II Computer Technical Information : Apple II Family Hardware Info

ftp://ground.ecn.uiowa.edu/2/apple2/miscinfo/hardware : May 2001 : 34 of 572

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 571 572

Caple C871i Manual do Utilizador Página 34

Comentários a estes Manuais

Caple C871i Manual do Utilizador Página 34

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Caple C871i