Caple C871i Manual do Utilizador descarregar pdf (Página 572)

100

101

Apple II Computer Info

booted software (e.g. to keep it from running too fast).

Some users believe that settings made to the Zip CDA panel (or to

the CDEV panel) get saved to BatRAM. They don't. When you turn OFF the

power they disappear. Also, the checked, "default", settings are not,

necessarily, the 'official' factory defaults. They are just the current

switch settings on the board.

If you are having problems with a stock ZipGS board, some things to

check are ...

1. that the board's connector tabs are making contact with the Slot

sprongers. This happens pretty close to the bottom of the card; so, be

sure the bottom 1/8 inch is clean.

2. that the ribbon cable from the board to the uP socket does not have

any breaks.

3. that the ZipGS plus other cards are not pulling more current than

your power setup can handle without producing noise glitches (i.e.

fatten the leads on your power supply and consider adding power jumpers

to the bottom of the motherboard).

> if I put in the stock 65c816 all is good

> the switch 4 setting on bank 1 of the Zip has no effect on this

Where are you plugging in the stock 65C816?

Rubywand

###################################################### E N D O F F I L E

### zipgs.prblms

###################################################### E N D O F F I L E

END OF DOCUMENT

Apple II Computer Technical Information : Apple II Family Hardware Info

ftp://ground.ecn.uiowa.edu/2/apple2/miscinfo/hardware : May 2001 : 572 of 572

1 2 ... 567 568 569 570 571 572

Caple C871i Manual do Utilizador Página 572

Comentários a estes Manuais

Caple C871i Manual do Utilizador Página 572

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Caple C871i